Learn how to completely disassemble the chassis of a Victa lawn mower.
- Socket Wrench – 11mm Socket
- Adjustable Spanner
- Flat Head Screw Driver
Remove the back wheels by first removing the plastic cover then the e-clip which holds them in place, they may now slide off the shaft. the front wheels may be removed by the same method, however if you would like to completely remove the axle with both wheels attached the height adjuster (held in by 1 e-clip) and axle clips must first be removed.
The rear axle is held in place by two bolts at the back of the chassis, on the bar underneath the catcher flap – after removing these the axle should come away (there are also brackets the bolts hold in place – don’t lose them).
The handle is held in place by two bolts and two brackets at the base – they are easily visible when viewing the mower from the top. There are also brackets on the under side. With everything removed the handles will come away.
To remove the catcher flap bend down both tabs on either side at the top of the flap and with a hammer and a screw driver tap the bar out and the flap will them come away.